Автор: Leo077 (---.nsk.dial.rol.ru)
Дата: давно
Мыжики есть такая операция как переобучение или калибровка стартерного пакета можно попробовать , в амерекоской програме Mitchell есть два варианта его калибровки, даю в оригинале во избежании недорозумений:
1 START CLUTCH CALIBRATION PROCEDURE
NOTE: When TCM, transaxle assembly, start clutch assembly, lower valve body assembly or engine assembly are replaced, TCM must memorize feedback signal for start clutch control. Perform following procedure to calibrate start clutch.
Apply parking brake and block front wheels. Connect SCS service connector to service check connector. See Fig. 5. Service check connector is located under dash on passenger side of vehicle. Start engine and warm to normal operating temperature (radiator fan comes on twice). Shift transaxle to "D" position. Fully depress brake pedal and accelerator for 20 seconds.
NOTE: Perform following step within one minute after radiator fan goes off.
Shift transaxle into "N" or "P" position. To store engine vacuum signal reading in memory, let engine idle in "N" or "P" position for one minute under the following conditions:
With brake pedal depressed.
With A/C switch off.
With combination light switch off.
With heater fan switch off.
Turn off all other electrical systems.
Shift transaxle into "D" position and let engine idle for 2 minutes to store feedback signal in memory under same conditions as in step 2). Connect scan tool to vehicle. Using scan tool, ensure TCM has completed start clutch calibration. Disconnect SCS service connector from service check connector.
NOTE: TCM will not store feedback signal when fluid temperature is less than 104 deg. F (40 deg. C) even if engine coolant temperature reaches normal operating temperature. Repeat these procedures until start clutch calibration is completed.
Эта была на автомобиль до 1997 г, на рисунке нарисован разъём двойной который необходимо перемкнуть и находится у пассажира вногах найти слохно но можно он обычно находится впаре с тройным разъёмом который идёт для сканера его лучше не трогать они часто воткнуты оба в зелёную резинку.А вот другая попытка адаптпции:
2 START CLUTCH CALIBRATION PROCEDURE
NOTE: When PCM, transaxle assembly, start clutch assembly, lower valve body assembly or engine assembly are replaced, PCM must memorize feedback signal for start clutch control. Perform following procedure to calibrate start clutch.
Start engine and warm to normal operating temperature (radiator fan comes on).
Shift transaxle to "D" position.
Turn off all electrical systems.
Road test vehicle up to 37 MPH (60 km/h). After speed reaches 37 MPH (60 km/h), release accelerator for 5 seconds. PCM will memorize feedback signal.
NOTE: PCM will not store feedback signal when fluid temperature is less than 104 deg. F (40 deg. C) even if engine coolant temperature reaches normal operating temperature. Repeat these procedures until start clutch calibration is completed.
| |